SECTION TSM 630.3PAGE 1 OF 13ISSUE HVIKING PUMP, INC. • A Unit of IDEX Corporation • Cedar Falls, IA 50613 USAVIKING PUMP, INC. • A Unit of IDEX Co
SECTION TSM 630.3 ISSUE H PAGE 10 OF 13When installing carbon graphite bushings, extreme care must be taken to prevent breaking. Carbon graphite i
SECTION TSM 630.3 ISSUE H PAGE 11 OF 13If a new spring is installed or if pressure setting of pressure relief valve is to be changed from that whic
SECTION TSM 630.3 ISSUE H PAGE 12 OF 13NOTE:1. Heat cartridges, temperature probes, and controllers must be wired by a licensed electrician to mee
SECTION TSM 630.3PAGE 13 OF 13ISSUE HVIKING PUMP, INC. • A Unit of IDEX Corporation • Cedar Falls, IA 50613 USA© 7/2014 Viking Pump Inc. All right
BEFORE opening any liquid chamber (pumping chamber, reservoir, relief valve adjusting cap fitting, etc.) be sure that : ● Any pressure in the chamber
SECTION TSM 630.3 ISSUE H PAGE 3 OF 13ROTATION: Viking pumps operate equally well in a clockwise or counterclockwise rotation. Shaft rotation dete
SECTION TSM 630.3 ISSUE H PAGE 4 OF 13ITEM NAME OF PART ITEM NAME OF PART ITEM NAME OF PART1 Locknut 16 Grease Fitting 31 Stud for Head2 Lockwasher
ASECTION TSM 630.3 ISSUE H PAGE 5 OF 13FIGURE 4FIGURE 5N-R BEARING HOUSING ASSEMBLYDISASSEMBLYDANGER !Before opening any Viking pump liquid chamber
SECTION TSM 630.3 ISSUE H PAGE 6 OF 132. Remove head gasket, idler and bushing assembly.3. Insert a length of hardwood or brass through port open
SECTION TSM 630.3 ISSUE H PAGE 7 OF 13DANGER !Before opening any Viking pump liquid chamber (pumping chamber, reservoir, relief valve adjusting cap
SECTION TSM 630.3 ISSUE H PAGE 8 OF 13FIGURE 6Cartridge Mechanical SealFIGURE 7Elastomeric o-ring and PTFE wedge seals generally require pump disas
SECTION TSM 630.3 ISSUE H PAGE 9 OF 13FIGURE 10For complete pump assembly instructions see Assembly, page 6.1. Clean shaft and seal housing bore.
Comments to this Manuals